Net-X-Tender  Installation Instructions

***Only fish finders/chart plotters of the same manufacturer can be connected together ***
             
    *** Please refer to the applicable wiring diagram during installation.   Garmin  Lowrance

What comes in the box?
1- Net-X-Tender V2.0 Unit
1- 4 foot power cable
1- Fuse holder assembly with one installed 2 Amp fuse
1- spare 2 Amp fuse
3- Solder seal wire connectors

1. Mount the Net-X-Tender V2.0 in the desired location using your chosen hardware. Mounting under the dash or in a closed compartment is desired. The Net-X-Tender V2.0 is water resistant not waterproof.
2. Route the adapter cables from the electronics to the Net-X-Tender V2.0 making sure that the proper end of the cables are in the desired location. A spare RJ-45 cable end is included with the Net-X-Tender V2.0 and an RJ-45 installation kit is available through Mofish.tech as well.
3. Route the power cable to the switched side of a DC source between 10 and 40 volts. Make sure to install the fuse assembly between the DC source and the power cable. 3 Solder Seal wire connectors are included to make the connections.
4. The input port is intended for connection to the sonar module (Garmin GLS-10 or Lowrance Active Target module). In reality, any fish finder/chart plotter can be connected to any of the ports, they are all the same. The screw on sealed cover is disassembled to allow fitting to the network cable. See Fig 1
5. Connect your fish finder chart plotters to ports 1 thru 4 as needed. See the appropriate diagram for your equipment. Garmin  Lowrance
6. The only setup involved with the Net-X-Tender V2.0 are the Networking settings in the individual fish finder chart/plotter units. Refer to the appropriate fish finder chart/plotter instruction manual.